%PDF- %PDF-
Direktori : /usr/src/linux-headers-5.15.0-43/arch/powerpc/include/asm/ |
Current File : //usr/src/linux-headers-5.15.0-43/arch/powerpc/include/asm/heathrow.h |
/* SPDX-License-Identifier: GPL-2.0 */ #ifndef _ASM_POWERPC_HEATHROW_H #define _ASM_POWERPC_HEATHROW_H #ifdef __KERNEL__ /* * heathrow.h: definitions for using the "Heathrow" I/O controller chip. * * Grabbed from Open Firmware definitions on a PowerBook G3 Series * * Copyright (C) 1997 Paul Mackerras. */ /* Front light color on Yikes/B&W G3. 32 bits */ #define HEATHROW_FRONT_LIGHT 0x32 /* (set to 0 or 0xffffffff) */ /* Brightness/contrast (gossamer iMac ?). 8 bits */ #define HEATHROW_BRIGHTNESS_CNTL 0x32 #define HEATHROW_CONTRAST_CNTL 0x33 /* offset from ohare base for feature control register */ #define HEATHROW_MBCR 0x34 /* Media bay control */ #define HEATHROW_FCR 0x38 /* Feature control */ #define HEATHROW_AUX_CNTL_REG 0x3c /* Aux control */ /* * Bits in feature control register. * Bits postfixed with a _N are in inverse logic */ #define HRW_SCC_TRANS_EN_N 0x00000001 /* Also controls modem power */ #define HRW_BAY_POWER_N 0x00000002 #define HRW_BAY_PCI_ENABLE 0x00000004 #define HRW_BAY_IDE_ENABLE 0x00000008 #define HRW_BAY_FLOPPY_ENABLE 0x00000010 #define HRW_IDE0_ENABLE 0x00000020 #define HRW_IDE0_RESET_N 0x00000040 #define HRW_BAY_DEV_MASK 0x0000001c #define HRW_BAY_RESET_N 0x00000080 #define HRW_IOBUS_ENABLE 0x00000100 /* Internal IDE ? */ #define HRW_SCC_ENABLE 0x00000200 #define HRW_MESH_ENABLE 0x00000400 #define HRW_SWIM_ENABLE 0x00000800 #define HRW_SOUND_POWER_N 0x00001000 #define HRW_SOUND_CLK_ENABLE 0x00002000 #define HRW_SCCA_IO 0x00004000 #define HRW_SCCB_IO 0x00008000 #define HRW_PORT_OR_DESK_VIA_N 0x00010000 /* This one is 0 on PowerBook */ #define HRW_PWM_MON_ID_N 0x00020000 /* ??? (0) */ #define HRW_HOOK_MB_CNT_N 0x00040000 /* ??? (0) */ #define HRW_SWIM_CLONE_FLOPPY 0x00080000 /* ??? (0) */ #define HRW_AUD_RUN22 0x00100000 /* ??? (1) */ #define HRW_SCSI_LINK_MODE 0x00200000 /* Read ??? (1) */ #define HRW_ARB_BYPASS 0x00400000 /* Disable internal PCI arbitrer */ #define HRW_IDE1_RESET_N 0x00800000 /* Media bay */ #define HRW_SLOW_SCC_PCLK 0x01000000 /* ??? (0) */ #define HRW_RESET_SCC 0x02000000 #define HRW_MFDC_CELL_ENABLE 0x04000000 /* ??? (0) */ #define HRW_USE_MFDC 0x08000000 /* ??? (0) */ #define HRW_BMAC_IO_ENABLE 0x60000000 /* two bits, not documented in OF */ #define HRW_BMAC_RESET 0x80000000 /* not documented in OF */ /* We OR those features at boot on desktop G3s */ #define HRW_DEFAULTS (HRW_SCCA_IO | HRW_SCCB_IO | HRW_SCC_ENABLE) /* Looks like Heathrow has some sort of GPIOs as well... */ #define HRW_GPIO_MODEM_RESET 0x6d #endif /* __KERNEL__ */ #endif /* _ASM_POWERPC_HEATHROW_H */