Current File : //usr/src/linux-headers-5.15.0-125-generic/drivers/scsi/arm/Kconfig
# SPDX-License-Identifier: GPL-2.0-only
#
# SCSI driver configuration for Acorn
#
config SCSI_ACORNSCSI_3
tristate "Acorn SCSI card (aka30) support"
depends on ARCH_ACORN && SCSI
select SCSI_SPI_ATTRS
help
This enables support for the Acorn SCSI card (aka30). If you have an
Acorn system with one of these, say Y. If unsure, say N.
config SCSI_ACORNSCSI_SYNC
bool "Support SCSI 2 Synchronous Transfers"
depends on SCSI_ACORNSCSI_3
help
Say Y here to enable synchronous transfer negotiation with all
targets on the Acorn SCSI card.
In general, this improves performance; however some SCSI devices
don't implement it properly, so the safe answer is N.
config SCSI_ARXESCSI
tristate "ARXE SCSI support"
depends on ARCH_ACORN && SCSI
help
Around 1991, Arxe Systems Limited released a high density floppy
disc interface for the Acorn Archimedes range, to allow the use of
HD discs from the then new A5000 on earlier models. This interface
was either sold on its own or with an integral SCSI controller.
Technical details on this NCR53c94-based device are available at
<http://www.cryton.demon.co.uk/acornbits/scsi_arxe.html>
Say Y here to compile in support for the SCSI controller.
config SCSI_CUMANA_2
tristate "CumanaSCSI II support"
depends on ARCH_ACORN && SCSI
help
This enables support for the Cumana SCSI II card. If you have an
Acorn system with one of these, say Y. If unsure, say N.
config SCSI_EESOXSCSI
tristate "EESOX support"
depends on ARCH_ACORN && SCSI
help
This enables support for the EESOX SCSI card. If you have an Acorn
system with one of these, say Y, otherwise say N.
config SCSI_POWERTECSCSI
tristate "PowerTec support"
depends on ARCH_ACORN && SCSI
help
This enables support for the Powertec SCSI card on Acorn systems. If
you have one of these, say Y. If unsure, say N.
comment "The following drivers are not fully supported"
depends on ARCH_ACORN
config SCSI_CUMANA_1
tristate "CumanaSCSI I support"
depends on ARCH_ACORN && SCSI
select SCSI_SPI_ATTRS
help
This enables support for the Cumana SCSI I card. If you have an
Acorn system with one of these, say Y. If unsure, say N.
config SCSI_OAK1
tristate "Oak SCSI support"
depends on ARCH_ACORN && SCSI
select SCSI_SPI_ATTRS
help
This enables support for the Oak SCSI card. If you have an Acorn
system with one of these, say Y. If unsure, say N.
Mini Shell